Contact Us
Qingdao Weiketerui Automation Equipment Co., Ltd
TEL: 0086-532-66960231
MOB: 008618562800715
Skype: amy_5310
E-mail: amy@wtr-bearing.com
Address: Wanxing International Hardware City, Qingdao, Shandong, China
The correct demagnetization operation of the automatic bearing heater is very important, different modes with different demagnetization operation, please automatically charge the following skills.
Time control mode of automatic bearing heater:
0-99.9min, set the heating time you need, when arrive the set time it will stop heating automatically, demagnetization work 3-4 seconds red light, heating demagnetization all completed. Move the car, remove the stem, you can remove the workpiece installation.
Temperature control mode of automatic bearing heater:
In the 0-300 ℃ range, set their own heating temperature, the temperature to automatically stop heating, demagnetization work time 3-4 seconds at the same time remove the temperature sensor red light, heating demagnetization all completed. Move the car, remove the stem, you can remove the workpiece installation.
Note: 300 ℃ temperature probe temperature limit. Local heating limit temperature up to 380 ℃, if you need to heat to 300 ℃ above, you can rely on the time heating mode to continue heating.
Emergency stop:
To stop the heating process heating, press the stop button to release the red button after 3 seconds, heating demagnetization all completed. Move the car, remove the stem, you can remove the workpiece.
About WTR automatic bearing heater, if you have more need for help, please call 008618562800715 or email at amy@wtr-bearing.com