News

How To Remove Sleeve in Rolling Mill By WTR Induction Heating Machine?

Mar 27, 2026 Leave a message

Project Background
During a routine shutdown in a steel rolling mill, the maintenance team needed to remove a large inner sleeve from a shaft assembly.
The part had been in service for a long time and was tightly fitted.
Traditional methods like gas heating or hammering were considered, but there were concerns about:
1) damaging the shaft
2) uneven heating
3) long working time
So induction heating was used instead.
Application Details
Application Inner sleeve removal
Industry Steel / Rolling mill
Workpiece size OD 500 mm / ID 300 mm / Length 470 mm
Heating temperature Around 350°C
Heating power 120 kW
Heating time About 13 minutes
 Do you know what happened on site?
The induction coil was wrapped directly around the sleeve area.
As heating started, the temperature was checked during the process to avoid overheating.
The heat was focused on the sleeve, so expansion happened where it was needed.
After reaching around 350°C, the sleeve loosened and was removed smoothly.
No hammering was required.

Why Induction Heating Method Worked Well?
Effect Explanation
Time saving The job was finished in minutes instead of hours
No damage The shaft and surrounding parts were kept in good condition
More control Heating could be adjusted and monitored at any time
Safer operation No open flame, which is important in steel plants
 Where This Is Commonly Used
1) Rolling mill maintenance
2) Bearing and sleeve removal
3) Coupling dismantling
4) Pre-heating before assembly

For tight-fit parts like sleeves or bearings, the removal method makes a big difference.
In this case, WTR induction heating machine helped the team finish the job faster and with less risk.

 

Welcome to contact WTR at amy@wtr-bearing.com to get more solutions for reference,such as installation, removal,PWHT,preheating. WTR induction heater factory will do best to offer help.

Send Inquiry